What Is The Speed Of The External Thread Of The CNC Lathe

Update:14-05-2020
Summary:

The pitch  value commanded CNC Tool Holder in the threa […]

The pitch  value commanded CNC Tool Holder in the thread machining block is equivalent to the feed speed F expressed by the feed amount . If the spindle speed of the machine tool is selected too high, the converted feed The speed  must greatly exceed the normal value At the beginning  end of its displacement, the tool will be constrained by the servo drive system's up  down frequency and the numerical control interpolation interpolation speed.

 

 

Because the up  down frequency cannot meet the processing requirements, it may be due to the main feed The lead and lag produced by the movement caused the pitch of some threads to be inconsistent;The turning thread must be realized by the synchronous operation function of the spindle, that is, the turning thread needs a spindle pulse generator encoder. When the spindle speed is selected too high, the positioning pulse sent by the encoder that is, a reference pulse signal sent by each revolution of the spindle may be caused by "overshoot especially when the quality of the encoder is unstable.

 

As a result, the thread of the workpiece will be disorderly buckled.Therefore, when turning threads, the determination of the spindle speed should follow the following principles.Under the condition of ensuring production efficiency and normal cutting, a lower spindle speed should be selected.When the lead-in length δ1 and cut-out length δ2 as shown in the figure in the thread processing block are considered to be sufficient, that is, when the thread feed distance exceeds the length of the specified thread on the drawing, a higher spindle can be selected.

 

Rotating speed.When the allowable working speed specified by the encoder exceeds the maximum speed of the spindle specified by the machine tool, you can choose a higher spindle speed as much as possible Under normal circumstances, the spindle speed n screwof the thread should be determined according to the calculation formula specified in the manual of the machine tool or numerical control system. The calculation formula is mostly.